Huawei OceanStor V5 Series Parts Replacement page 191

OceanStor V5 Series
Parts Replacement
2.
You can proceed to next steps only when all items pass the pre-replacement check
and the replacement page is displayed. If any item fails, rectify the fault as
prompted.
Step 2 Wear an ESD wrist strap.
Step 3 Remove the two interface modules from the controller to be replaced.
1.
2.
3.
Issue 15 (2019-12-30)
Check the status of the parts to be replaced.
Start SmartKit and choose Home > Storage > Parts Replacement > Parts
Replacement. On the Parts Replacement page, click FRU Replacement.
Then complete the check before the replacement as prompted. For details, see
7.1.3 Replacing an
NO TICE
Check the status of the Power indicator/Hot Swap button on the interface
module to determine whether the interface module has been successfully
powered off, as shown in
– If the indicator is off, the interface module has been successfully powered
off. Proceed to
– If the indicator is on, use a paper clip or a similar object to press the
Power indicator/Hot Swap button on the interface module to power off
the interface module.
Figure 7-44 Power indicator/Hot Swap button on an interface module
Remove the cables from the interface module.
Press the latch on the interface module to release the handle and pull out the
interface module, as shown in
Copyright © Huawei Technologies Co., Ltd.
FRU.
Figure 7-44.
Step 3.2.
Figure 7-45.
7 Replacing FRUs
182