Huawei OceanStor V5 Series Parts Replacement page 235

OceanStor V5 Series
Parts Replacement
●
●
Tools and Materials
●
●
●
Procedure
Step 1 Check status before replacement.
1.
2.
You can proceed to next steps only when all items pass the pre-replacement check
and the replacement page is displayed. If any item fails, rectify the fault as
prompted.
Step 2 Wear an ESD wrist strap.
Step 3 Check the status of the Power indicator/Hot Swap button on the interface module
to determine whether the interface module has been successfully powered off, as
shown in
●
Issue 15 (2019-12-30)
information will not be restored, but the VLANs, logical ports, and bonded
ports on the Ethernet interface module will be restored.
If you replace an interface module that uses Fibre Channel protocol with one
that uses Ethernet protocol, the Fibre Channel port configuration information
will be deleted. If you replace the interface module again with one that uses
Fibre Channel protocol, the Fibre Channel port configuration information will
not be restored.
If you want to use interface modules of different types, contact Huawei
technical support.
ESD wrist strap
ESD bag
Label
Check system status.
Start SmartKit and choose Home > Storage > Routine Maintenance >
Health Check. On the Health Check page, perform inspection as instructed.
For details, see 7.1.2 Checking System
If any items fail the inspection, rectify the faults by performing the recommended
actions in the inspection reports. Ensure that all other parts except the parts to be
replaced are working properly.
Check the status of the parts to be replaced.
Start SmartKit and choose Home > Storage > Parts Replacement > Parts
Replacement. On the Parts Replacement page, click FRU Replacement.
Then complete the check before the replacement as prompted. For details, see
7.1.3 Replacing an
NO TICE
Figure 7-79.
If the indicator is off, the interface module has been successfully powered off.
Proceed to Step 4.
Copyright © Huawei Technologies Co., Ltd.
Status.
FRU.
7 Replacing FRUs
226