Replacing A Cable - Huawei OceanStor V5 Series Parts Replacement

OceanStor V5 Series
Parts Replacement
Step 4 Pull the mini SAS HD cable connector out of the port and put it in to an ESD bag.
Step 5 Take the spare part out of the ESD bag.
Step 6 Insert the replacement mini SAS HD cable vertically into the original position, as
shown in
Figure 7-78 Connecting a mini SAS HD cable
Step 7 View the Port indicator, and determine whether the installation is successful.
●
●
Step 8 Confirm the replacement.
After the preceding procedure is complete, check services on the host for storage-
related errors. If any storage-related error is reported, contact Huawei technical
support.
----End
Follow-up Procedure
Label the replaced cable to facilitate subsequent operations.

7.6.3 Replacing a Cable

This section describes how to replace a cable.
Impact on the System
Replacing a cable may affect or even interrupt system services. Replace the cable
in off-peak hours and back up data in advance to avoid unexpected service
interruption.
Prerequisites
●
Issue 15 (2019-12-30)
Figure 7-78.
If the indicator is steady green or blue, the cable is successfully installed.
If the indicator is steady red or off, the newly installed cable is faulty, the
cable slot is faulty, or the cable is incorrectly installed.
A spare part is on hand.
Copyright © Huawei Technologies Co., Ltd.
7 Replacing FRUs
221