Huawei OceanStor V5 Series Parts Replacement page 158

OceanStor V5 Series
Parts Replacement
Procedure
Step 1 Check status before replacement.
1.
2.
You can proceed to next steps only when all items pass the pre-replacement check
and the replacement page is displayed. If any item fails, rectify the fault as
prompted.
Step 2 Wear an ESD wrist strap and remove the cables from the system subrack that you
want to replace.
Step 3 Take the spare part out of its ESD bag and place it on the ESD table.
Step 4 Remove components from the system subrack that you want to replace and
reinstall them to their corresponding positions on the spare part.
Step 5 Remove the system subrack that you want to replace from the cabinet, as shown
in
1.
2.
Issue 15 (2019-12-30)
Check system status.
Start SmartKit and choose Home > Storage > Routine Maintenance >
Health Check. On the Health Check page, perform inspection as instructed.
For details, see 7.1.2 Checking System
If any items fail the inspection, rectify the faults by performing the recommended
actions in the inspection reports. Ensure that all other parts except the parts to be
replaced are working properly.
Check the status of the parts to be replaced.
Start SmartKit and choose Home > Storage > Parts Replacement > Parts
Replacement. On the Parts Replacement page, click FRU Replacement.
Then complete the check before the replacement as prompted. For details, see
7.1.3 Replacing an
NO TICE
Figure 7-14.
Use the Phillips screwdriver to loosen the M6 screws from the system subrack.
Pull the system subrack out of the cabinet along guide rails and place the
system subrack on the ESD table.
Copyright © Huawei Technologies Co., Ltd.
Status.
FRU.
7 Replacing FRUs
149