Huawei OceanStor V5 Series Parts Replacement page 227

OceanStor V5 Series
Parts Replacement
Do not look into the optical port without eye protection. The laser beam on the
optical interface board or from the fiber may cause injuries to eyes.
Figure 7-73 Installing the MPO end of the optical fiber
Step 7 Take the dustproof caps off the DLC ends of the optical fiber and insert the optical
fiber into the ODF distribution box, as shown in
Do not look into the optical port without eye protection. The laser beam on the
optical interface board or from the fiber may cause injuries to eyes.
Figure 7-74 Installing the DLC ends of the optical fiber
Step 8 View the Port indicator, and determine whether the installation is successful.
●
●
Step 9 Confirm the replacement.
1.
2.
Issue 15 (2019-12-30)
If the indicator is steady green or blue, the optical module has been
successfully installed.
If the indicator is steady red or off, the newly installed MPO-4*DLC optical
fiber is faulty, or incorrectly installed.
Perform a post-replacement inspection.
After the parts replacement, return to the SmartKit page and click Replaced.
Then complete the parts check after the replacement as prompted.
Check system status.
Copyright © Huawei Technologies Co., Ltd.
7 Replacing FRUs
Figure 7-74.
218