Huawei OceanStor V5 Series Parts Replacement page 234

OceanStor V5 Series
Parts Replacement
●
Precautions
●
●
●
●
●
●
Issue 15 (2019-12-30)
The cable connection positions of the interface module that you want to
replace are labeled on the cables.
The type of the spare part must be same as that of the one you want to
replace. Otherwise, parts replacement will fail and the configuration of the
interface module will be lost. If the configuration of the interface module is
lost, collect logs and contact Huawei technical support.
NO TICE
For V500R007C30, SmartIO interface modules include a number of different
versions. The specifications of the SmartIO interface modules vary across
different versions. Therefore, SmartIO interface modules of different versions
are not interchangeable. You can identify the versions of the SmartIO
interface modules by viewing the labels attached to the handles.
● Earlier versions: "SmartIO" on the labels attached to the handles.
● Latest version: "SmartIO+
attached to the handles.
For details, see the descriptions about interface modules in the
Description specific to your product model.
Note the following if you want to replace a SmartIO interface module:
– For the new SmartIO interface module without an optical module
Remove the optical module from the SmartIO interface module you want
to replace and insert the new SmartIO interface module into the
controller enclosure. After the Power indicator of the new interface
module is steady green, wait at least one minute and insert the removed
optical module into the new SmartIO interface module.
– For the new SmartIO interface module with an optical module
Insert the new SmartIO interface module into the controller enclosure. If
you want to use the optical module on the replaced interface module,
wait at least one minute after the Power indicator of the new SmartIO
interface module is steady green, and then insert the optical module into
the new SmartIO interface module.
Remove and insert an interface module with even force. Excessive force may
damage the appearance or connectors of the interface module.
An interface module must be replaced within five minutes. Otherwise, the
system heat dissipation is compromised.
After removing an interface module, wait at least fifteen seconds before
inserting one. Otherwise, the system cannot identify the status change of the
interface module.
If you replace an interface module that uses Ethernet protocol with one that
uses Fibre Channel protocol, the Ethernet port configuration information will
be deleted, and VLANs, logical ports, and bonded ports on the original
interface module will become unavailable. If you replace the interface module
again with one that uses Ethernet protocol, the Ethernet port configuration
Copyright © Huawei Technologies Co., Ltd.
rate " such as "SmartIO+8Gb FC" on the labels
7 Replacing FRUs
Product
225