Huawei OceanStor V5 Series Parts Replacement page 236

OceanStor V5 Series
Parts Replacement
●
Figure 7-79 Power indicator/Hot Swap button on an interface module
Step 4 Remove the cables from the interface module that you want to replace.
Step 5 Press the latch on the interface module and pull out the interface module, as
shown in
Figure 7-80 Removing an interface module
Issue 15 (2019-12-30)
If the indicator is on, use a paper clip or a similar object to press the Power
indicator/Hot Swap button on the interface module to power off the interface
module.
Figure 7-80.
This figure uses a 2 U controller enclosure as an example. The method used to replacing an
interface module for a 3 U or 6 U controller enclosure is the same as that for a 2 U
controller enclosure.
Copyright © Huawei Technologies Co., Ltd.
7 Replacing FRUs
227