YASKAWA E-S Series Product Manual page 252

11.1 List of Parameters
11.1.1 Interpreting the Parameter Lists
11.1 List of Parameters
11.1.1 Interpreting the Parameter Lists
Parameter
No.
Pn000
11.1.2 List of Parameters
The following table lists the parameters.
Note: Do not change the following parameters from their default settings.
Parameter
No.
Pn000
11-2
Size Name
Basic Function
2
Selections 0

n. X Rotation Direction Selection
0
1
 
n. X Reserved parameter (Do not change.)
 
n. X Reserved parameter (Do not change.)

n.X Reserved parameter (Do not change.)
• Reserved parameters
• Parameters not given in this manual
Size Name
Basic Function
2
Selections 0

n. X Rotation Direction Selection
0
1
 
n. X Reserved parameter (Do not change.)
 
n. X Reserved parameter (Do not change.)

n.X Reserved parameter (Do not change.)
This is when any change made to the parameter will become effective.
If you change any parameters that are enabled after restarting, either
turn the power supply OFF and ON again or perform a software reset.
Setting Setting
Range Unit
0000h to
−
00B3h
There are the following two classifications.
• Setup
• Tuning
Refer to the following section for details.
Use CCW as the forward direction.
Use CW as the forward direction. (Reverse Rotation Mode)
Setting Setting
Range Unit
0000h to
−
00B3h
Use CCW as the forward direction.
Use CW as the forward direction. (Reverse Rotation Mode)
Default When Classi-
Setting Enabled fication
After
Setup
0000h
restart
5.1.1 Parameter Classification on page 5-3
Default When Classi-
Setting Enabled fication
After
0000h Setup
restart
Continued on next page.
Reference
−
Reference
page 5-23
Reference
−
Reference
page 5-23