2.6
Removal and Installation of Options
[A] Finisher
(1)
Press the [ON/OFF] button on the control
panel to shut down the equipment.
(2)
Turn the power OFF using the main power
switch on the right-hand surface of the
equipment.
(3)
Unplug the power cable.
(4)
Take off the connector cover and unplug the
interface cable.
(5)
Remove 1 screw and take off the finisher
from the slide rail.
Note:
When moving the finisher unit by itself, be
careful that it does not topple over.
[B] Large Capacity Feeder (LCF)
(1)
Press the [ON/OFF] button on the control
panel to shut down the equipment.
(2)
Turn the power OFF using the main power
switch on the right-hand surface of the
equipment.
(3)
Unplug the power cable.
(4)
Press the button to separate the Large
Capacity Feeder (LCF) from the equipment.
e-STUDIO555/655/755/855
OUTLINE OF THE MACHINE
Interface cable
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
2 - 46
Connector cover
Fig. 2-44
Slide rail
Fig. 2-45
Fig. 2-46