Toshiba e-STUDIO555 Service Manual page 251

[F] Auto-toner sensor (S12)
(1) Take out the developer material.
( P.11-17 "[D] Developer material")
(2) Release the harness from the clamp and pull
out the harness.
(3) Remove 2 screws to take off the auto-toner
sensor.
[G] Guide roller
[G-1] Guide roller on the front side
(1) Take off the developer unit.
( P.11-16 "[C] Developer unit")
(2) Remove 2 screws, take off the bracket and
then remove 3 gears.
(3) Remove 1 E-ring and then the spring.
(4) Remove 2 E-rings and take off 2 guide
rollers.
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
Auto-toner sensor
Fig. 11-29
Screw
Bracket
Screw
Fig. 11-30
Guide roller
Fig. 11-31
11 - 19
Spring
E-ring
E-ring
e-STUDIO555/655/755/855
DEVELOPER UNIT
11