Toshiba e-STUDIO555 Service Manual page 68

Symbol Name
M26 IH-FAN-MOT
IH board cooling fan
M27 DCT-O-FAN-MOT
Duct out fan
M28 FUS-FAN-MOT
Fuser cooling fan
M29 EXIT-FAN-MOT
Exit section cooling fan
M30 DCT-I-FAN-MOT
Duct in fan
M31 DEV-FAN-MOT
Developer unit fan
M32 LSU-FAN-MOT
Laser unit cooling fan
M33 SYS-FAN-MOT
SYS board cooling fan
M34 PS-FAN-MOT1
Switching regulator cooling
fan-1
M35 PS-FAN-MOT2
Switching regulator cooling
fan-2
M41 LCF-TRY-MOT
Tandem LCF tray-up motor
M42 LCF-ENDF-MOT
Tandem LCF end fence
motor
MR1 Original feed motor
MR2 Read motor
MR3 Original reverse motor
MR4 Original exit motor
FR1 RADF cooling fan
e-STUDIO555/655/755/855
OUTLINE OF THE MACHINE
Function
Cooling down the IH board
Suctioning ozone generated at charging
Cooling down the fuser
Cooling down the exit section
Cooling down the developer unit
Suctioning toner
Cooling down the laser unit
Cooling down the SYS board, SYSIF board
and hard disk
Cooling down the switching regulator
(rear side)
Cooling down the switching regulator
(lower side)
Lifting up the tray in the tandem LCF
(Only for NAD/SAD/ARD/ASD/AUD/MJD/
CND/TWD model of all equipments)
Driving the end fence in the tandem LCF
(Only for NAD/SAD/ARD/ASD/AUD/MJD/
CND/TWD model of all equipments)
Driving the original feed roller, pickup roller
and registration roller
Transporting originals by driving the
intermediate transport roller, front read
roller, rear read roller and reverse
registration roller
Driving the original reverse roller
Driving the original exit roller
Cools off the RADF drive section.
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
2 - 32
Remarks P-I
Fig. 2-18 24-17
Fig. 2-18 33-3
Fig. 2-18 33-3
Fig. 2-18 33-3
Fig. 2-19 42-25
Fig. 2-19 42-13
Fig. 2-19 32-9
Fig. 2-23 54-8
Fig. 2-23 52-14
Fig. 2-23 52-14
Fig. 2-22 31-34
Fig. 2-22 9-22
Fig. 2-29 87-14
Fig. 2-29 87-7
Fig. 2-29 87-28
Fig. 2-29 87-9
Fig. 2-29 89-16