Toshiba e-STUDIO555 Service Manual page 184

[B] Intermediate transport unit
(1) Take off the first paper feeder unit.
( P.8-17 "[A] Paper feeder unit / Bypass
feed unit")
(2) Disconnect 1 connector and remove 3
screws to take off the intermediate transport
unit.
[B-1] Motor driving PC board (MOT2-MT)
(1) Release the harness from the harness
clamp. Then remove 2 screws to take off the
bracket.
Note:
Be careful not to drop the gear because it will
comes out of place when its bracket is taken
off.
(2) Remove 1 screw on the varistor.
(3) Removing 4 screws and 4 bushings to take
off the paper guide.
e-STUDIO555/655/755/855
PAPER FEEDING SYSTEM
Paper guide
Varistor
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
8 - 22
Intermediate transport unit
Fig. 8-27
Gear
Bracket Gear
Fig. 8-28
Fig. 8-29