Toshiba e-STUDIO555 Service Manual page 110

No. Message
23 READY
(FINISHER IN USE)
24 READY
(ADD TAB SHEET)
25 Ready for bypass feeding
26 COPYING
27 Auto Start
28 Place Doc. Feeder in the
down position
29 Place originals in the
document feeder
30 Change direction of original Displayed when the direction of
31 PRESS [BASIC] and select
normal paper size
32 Place last %d originals in
doc.
feeder entrance tray
33 Add paper
34 Cannot duplex this size
35 Cannot use this media type Displayed when the paper size which
36 Set standard size
37 Cannot staple this paper
type
38 Cannot duplex this size
39 Cannot use transparency
film
40 Copy size: A4/LT only
41 Copy size: A4/LT and A4-
R/LT-R
42 CHANGE DRAWER TO
CORRECT PAPER SIZE
43 Change drawer to correct
media type
e-STUDIO555/655/755/855
CONTROL PANEL
State of equipment
Finisher manual operating
• The equipment is ready for
scanning and waiting for the
operator to select the copying
conditions.
No tab paper
• The equipment is ready for
scanning and waiting for the
operator to select the copying
conditions.
Paper is set on the bypass tray
At the copying state
Auto Start is set during printing
RADF is open when original is placed
on RADF
Displayed when the conditions are set
and [START] button is pressed with
no original placed
original placed is different from the
setting
Displays the warning that the copy is
not enabled when any drawer but
bypass feed is selected at Cover
Sheet Copying Mode or Sheet
Insertion Mode
Paper jam occurred during copying
(RADF scanning)
Displayed when the paper in selected
drawer is running out
Displayed when the paper size which
is not specified for duplex copying is
set
is not specified for the functions such
as stapling or hole punching is set
Displayed when the paper size which
is not acceptable is set (depends on
the setting)
Displayed when the paper type which
can not be stapled is set at Cover
Sheet Copying Mode/Sheet Insertion
Mode
Displayed when the paper size which
is not specified for duplex copying is
set
Displayed when the paper type which
can not be punched is set at Cover
Sheet Copying Mode/Sheet Insertion
Mode
Displayed when the paper size which
is not specified for "Book-type duplex
copying" or "Dual-page" is set
Displayed when the paper size which
is not specified for "Rotate Sort"
Displayed when the selected paper
size is not in the drawer
Displayed when the selected media
type is not in the drawer
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
5 - 4
Note
Printing is started when pressing the
[START] button.
Printing is resumed when the
[START] button is pressed under the
condition the printing UI is displayed
([JOB STATUS] button pressed)
after adding tab paper.
Cleared by pressing [FUNCTION
CLEAR] button
Cleared by closing RADF
Cleared by setting the original
Re-set the paper size
Re-set the paper type
Re-set the paper type