Toshiba e-STUDIO555 Service Manual page 140

[D] SLG board cooling fan (M23)
(1) Take off the lens cover
( P.6-14 "[B] Lens cover").
(2) Disconnect 1 connector and remove 2
screws to take off the SLG board cooling fan.
[E] Exposure lamp (EXP)
(1) Take off the top rear cover
( P.2-42 "[E] Top rear cover").
(2) Take off the original glass
( P.6-13 "[A] Original glass").
(3) Move the carriage-1 to the left side.
(4) Disconnect the connector, release the clamp
and remove 1 screw of the exposure lamp.
e-STUDIO555/655/755/855
SCANNING SECTION
SLG board cooling fan
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
6 - 16
Fig. 6-23
Carriage-1
Fig. 6-24
Fig. 6-25