Toshiba e-STUDIO555 Service Manual page 146

(4) Remove the wire and slant the carriage-2 to
take it out upward.
[J] Lamp inverter board (INV-EXP)
(1) Take off the carriage-1
( P.6-19 "[H] Carriage-1").
(2) Disconnect 2 connectors and remove 2
screws to take off the lamp inverter board.
[K] Scan motor [M1]
(1) Take off the top rear cover and the rear cover
( P.2-42 "[E] Top rear cover",
P.2-45 "[L] Rear cover").
(2) Disconnect the connector of the scan motor.
Then remove 2 screws to take off the scan
motor.
e-STUDIO555/655/755/855
SCANNING SECTION
Carriage-2
Carriage-1
Scan motor
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
6 - 22
Fig. 6-41
Lamp inverter board
Fig. 6-42
Fig. 6-43