Toshiba e-STUDIO555 Service Manual page 302

[K] Web motor (M4) / Fuser transport sensor (S9)
(1) Take off the fuser unit
( P.13-17 "[B] Fuser unit").
(2) Take off the cleaning web unit
( P.13-18 "[C] Cleaning web unit /
Cleaning web").
(3) Remove 2 screws to take off the fuser unit
front cover.
(4) Remove 2 screws and open the lower
separation finger unit.
(5) Release the harness from the harness end-
holder and then disconnect 1 connector.
(6) Remove 2 screws and take off the web
motor.
Note:
Pay attention to the size (length) of the
screws. If incorrect ones are used, the motor
could be damaged.
e-STUDIO555/655/755/855
FUSER UNIT
Lower separation finger unit
Web motor
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
13 - 28
Fuser unit front cover
Fig. 13-43
Fig. 13-44
Fig. 13-45