Toshiba e-STUDIO555 Service Manual page 198

[J-2] Tandem LCF end fence motor (M42)
(1) Remove 1 E-ring and take off 1 bushing.
(2) Disconnect 1 connector, remove 3 screws
and take off the motor with the bracket.
Note:
When assembling, wire the harness and fix it
with filament tape as shown in the figure.
(Be sure not to wire it on the side of the
motor.)
(3) Release 2 gear latches and remove the gear.
e-STUDIO555/655/755/855
PAPER FEEDING SYSTEM
Harness
Filament tape
Motor
Latch
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
8 - 36
Tandem LCF
end fence motor
Bushing E-ring
Fig. 8-67
Harness
Motor
Fig. 8-68
Gear
Fig. 8-69