Toshiba e-STUDIO555 Service Manual page 186

(3) Remove 2 E-rings to pull out the transport
rollers from the shaft.
[B-4] Intermediate transport sensor (S17)
(1) Disconnect 1 connector.
(2) Take off the sensor while the sensor arm is
pushed downward (the shield plate is pushed
upward).
Note:
When installing the sensor, make sure the
sensor arm moves properly.
[C] Bypass feed unit
(1) Take off the bypass feed unit.
( P.8-17 "[A] Paper feeder unit / Bypass
feed unit")
[C-1] Bypass feed roller / Pickup roller
(1) Remove 1 clip and 1 bushing and displace
the bypass transport roller.
e-STUDIO555/655/755/855
PAPER FEEDING SYSTEM
Transport roller
Sensor arm
Bypass transport roller
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
8 - 24
Fig. 8-33
Intermediate transport sensor
Fig. 8-34
Bushing
Fig. 8-35
Clip