Toshiba e-STUDIO555 Service Manual page 112

No. Message
67 Cannot copy
Check DEPARTMENT
COUNTER
68 Select the same sized Tab
sheets as the originals
69 Select the same sized
Inserter sheets as the
originals
70 Set Tab sheets in the same
direction as the originals
71 Set Inserter sheets in the
same direction as the
originals
72 Only one paper source can
be used with Cover Sheet
feature
73 Only two paper sources
can be used with Sheet
Insertion feature
74 ADD PAPER TO
INSERTER FEEDER
75 Set the paper source for
Tab sheet
76 Fuser cleaning web
decreased
77 Time for periodic
maintenance
(Fuser cleaning web)
78 Tab size: A4/LT only
79 Not enough memory to
store original(s)
Will you print out stored
originals?
80 Not enough memory to
store original(s)
Will you send stored
originals in?
81 Not enough memory to
store original(s)
Will you save stored
originals in?
82 The number of originals
exceeds the limits
Will you copy stored
originals?
83 The number of originals
exceeds the limits.
Will you send stored
originals?
84 The number of originals
exceeds the limits.
Will you save stored
originals?
e-STUDIO555/655/755/855
CONTROL PANEL
State of equipment
Displayed when the number of
printouts exceeds the limit number of
department counter
Displayed when the paper sizes for
the tab sheets and originals are
different
Displayed when the paper sizes for
inserter paper and original are
different
Displayed when the paper directions
for tab paper and original are different
Displayed when the paper directions
for inserter paper and original are
different
Displayed when both the cover sheet
mode and inserter cover sheet mode
are selected
Displayed when all the sheet insertion
mode, tab insertion mode and inserter
sheet insertion mode are selected
Displayed when the inserter mode is
valid and the [START] button is
pressed without papers on the tray
Displayed when the tab paper mode
is valid and the tab drawer is not
selected
Displayed when the fuser unit
cleaning web gets decreased
* This message is set not to be
displayed at shipment, but the
setting can be changed at the
setting mode (08-941).
Displayed when the fuser unit
cleaning web gets run out
Displayed when the tab paper mode
is valid and other than A4/LT is
selected for the tab paper size
Displayed when confirming the user
to print out the data as much as
stored at memory - full state
Displayed when confirming the user
to send the FAX data as much as
stored at memory - full state
Displayed when confirming the user
to save the scanning data as much as
stored at memory-full state
Displayed when confirming the user
to print out the data as much as
stored at memory-full state
Displayed when confirming the user
to send the FAX data as much as
stored at memory-full state
Displayed when confirming the user
to save the scanning data as much as
stored at memory-full state
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
5 - 6
Note
Select the same size for tab sheets
and originals.
Select the same size for the inserter
sheets and originals.
Set the tab sheets in the same
direction as the originals.
Set the inserter sheets in the same
direction as the originals.
Release either the cover sheet mode
or inserter cover sheet mode.
Release any of three modes
• Release the inserter mode
• Set papers on the inserter tray
Select the 2nd drawer property to
the tab to release this state.
Replace the cleaning web.
Replace the cleaning web.
Select A4 or LT for tab paper.
Displayed only in FAX Function
Displayed only in FAX Function
Displayed only in FAX Function
Displayed only in Scanning Function