[H] Drum motor (M11) / Motor driving PC board (MOT)
(1)
Take off the rear cover, SYS board and then
hard disk with its bracket.
(2)
Remove 3 screws to take off the drum wheel.
(3)
Disconnect 1 connector and remove 3
screws to take off the drum motor with its
bracket.
Note:
When installing the drum motor, tighten the
screw while the bracket is pushed against
the motor in the direction of the arrow.
(4)
Remove 3 screws to take off the drum motor.
[I]
Cleaning brush drive motor (M13) / Drum separation finger solenoid (SOL1)
(1)
Take off the exhaust duct.
(
P.9-14 "[F] Exhaust duct")
(2)
Remove 1 screw and take off the stay.
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
Drum wheel
Screw
Fig. 10-24
Drum motor
Screw
Screw
Fig. 10-25
Fig. 10-26
10 - 13
Screw
Connector
Stay
e-STUDIO555/655/755/855
DRUM/CLEANER UNIT
10