Toshiba e-STUDIO555 Service Manual page 111

No. Message
44 Select a paper size for
bypass feeding
45 Place the blank sheets in
bypass tray and select the
paper size
46 Place the blank sheets in
the same direction as the
originals
47 Place the same size blank
sheets as the originals
48 Place insertion sheets in
the bypass tray and select
the paper size
49 Select the same size
insert1 sheets as the
originals
50 Select the same size
insert2 sheets as the
originals
51 Set insert1 sheets in the
same direction as the
originals
52 Set insert2 sheets in the
same direction as the
originals
53 Set transparency film in A4/
LT direction
54 CANNOT PUNCH THIS
SIZE PAPER
55 Remove paper from the
finisher
56 Cannot staple this size
57 Remove paper from the
saddle stitch unit
58 Examine stapler
59 Check staple cartridge
60 Check staple cartridge in
the saddle stitch unit
61 Job interrupted job 1 saved Interrupt copying is accepted
62 Ready to resume job 1
63 Cannot use AMS mode
64 More than 200% is not
available
65 Updated the template
setting
66 Enter Department Code
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
State of equipment
Displayed when paper size needs to
be specified for bypass feeding such
as duplex copying
Displayed when no paper is in the
selected feeder at Cover Copying
Mode
Displayed when the direction of cover
page is different from that of other
pages at Cover Copying Mode
Displayed when the paper size of
cover page is different from that of
other pages at Cover Copying Mode
Displayed when no insertion sheet is
in the selected drawer at Sheet
Insertion Mode
Displayed when the size of insertion
sheet (sheet 1) is different from that of
other pages at Sheet Insertion Mode
Displayed when the size of insertion
sheet (sheet 2) is different from that of
other pages at Sheet Insertion Mode
Displayed when the direction of
insertion sheet (sheet 1) is different
from that of other pages at Sheet
Insertion Mode
Displayed when the direction of
insertion sheet (sheet 2) is different
from that of other pages at Sheet
Insertion Mode
Displayed when the selected paper
size is other than A4/LT at OHP mode
Displayed when the selected paper
size is not specified for hole punching
Displayed when the paper sizes are
mixed at Staple Sorting Mode
Displayed when the paper size is not
specified for stapling at Staple Sorting
Mode
Finisher is full of papers
Trouble in the stapler unit in finisher
No stapler in finisher section
No stapler in saddle stitch unit
Interrupt copying is cancelled
(finished)
Displayed when reproduction ratio is
set to be over 200% at AMS Mode on
RADF
Displayed when reproduction ratio is
set manually to be over 200% on
RADF
Displayed when the template stored is
recalled by pressing [TEMPLATE]
button
Displayed when a button is pressed
while the department management
setting is available
5 - 5
Note
Set the reproduction ratio 200% or
below manually
Set the reproduction ratio 200% or
below
e-STUDIO555/655/755/855
CONTROL PANEL
5