Toshiba e-STUDIO555 Service Manual page 316

[G] Exit roller
(1) Take off the exit/reverse unit
( P.14-9 "[A] Exit/Reverse unit").
(2) Remove the E-ring, gear and pin.
(3) Remove 2 E-rings and take off the exit roller
by sliding 2 bearings to the inside.
[H] Reverse section driving unit / Reverse motor driving PC board (MOT2-RV board)
(1) Take off the exit/reverse unit
( P.14-9 "[A] Exit/Reverse unit").
(2) Disconnect 1 connector, remove 6 screws
and then take off the reverse section driving
unit.
(3) Release 4 locking supports to take off the
MOT2-RV board.
e-STUDIO555/655/755/855
EXIT/REVERSE SECTION
Exit roller
Pin
Gear
Reverse section driving unit
Reverse motor driving PC board
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
14 - 12
Fig. 14-17
Fig. 14-18
Fig. 14-19