[K] Paddle
(1)
Take off the mixer. (
(2)
Remove 1 E-ring, the gear and parallel pin
on the rear side.
(3)
Remove 1 screw, 1 E-ring and then the
paddle bushing on the rear side.
(4)
Replace the oil seal pressed into the paddle
bushing, if necessary.
* Procedure for replacing an oil seal:
(
P.11-25 "Fig. 11-47 ")
(5)
Remove the gear, 1 E-ring and then paddle
bushing on the front side.
(6)
Replace the oil seal pressed into the paddle
bushing, if necessary.
(7)
Take out the paddle.
* Procedure for replacing an oil seal:
(
P.11-25 "Fig. 11-47 ")
<< Procedure for replacing an oil seal>>
In the developer unit, the oil seals are used at the
following 9 places.
•
Rear side of the upper and lower developer
sleeve (1 for each)
•
Front side of the transport sleeve (1)
•
Rear and front side of the mixer (2 for each)
•
Rear and front side of the paddle (1 for each)
e-STUDIO555/655/755/855
DEVELOPER UNIT
P.11-23 "[J] Mixer")
11 - 24
Fig. 11-44
Paddle bushing
Fig. 11-45
Paddle
Fig. 11-46
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
Gear
E-ring
Paddle bushing