Toshiba e-STUDIO555 Service Manual page 121

(4) Remove 9 screws and then disconnect 1
shielding wire and 1 connector. Then take off
the base stay.
Note:
When assembling, do not forget to connect
the connector and shielding wire.
(5) Disconnect 3 connectors.
(6) Remove 3 screws and take off the DSP
board and the sheet.
[D] KEY board (KEY)
(1) Take off the control panel unit.
P.5-12 "[A] Control panel unit"
(2) Disconnect 2 connectors of the LCD inverter
board.
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
Base stay
Fig. 5-16
DSP board
Fig. 5-17
Fig. 5-18
5 - 15
Connector
Shielding wire
Sheet
LCD inverter board
e-STUDIO555/655/755/855
CONTROL PANEL
5