Toshiba e-STUDIO555 Service Manual page 214

(5) Disconnect 2 connectors, remove 1 screw,
and then take off the wire cleaner position
detection switch (SW4).
Note:
Push the switch in the direction of arrow A to
fix it. Also, carefully insert the connector into
the terminal of the color of the harness, and
then bend the terminal 45 º.
[C] Discharge LED (ERS)
(1) Take off the wire cleaner drive unit.
( P.9-11 "[B] Wire cleaner drive unit / Wire
cleaner drive motor (M12)")
(2) Disconnect 1 connector.
(3) Lift the connector side of the discharge LED
slightly to release the lock, and then slowly
pull out the discharge LED from the guide.
Note:
Assemble the discharge LED so that all
fingers of the guide are hooked.
e-STUDIO555/655/755/855
PROCESS RELATED SECTION
Black Purple Connector
Latch
Discharge LED
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
9 - 12
Screw
( A )
Fig. 9-15
Connector
Fig. 9-16
Lock pin
Discharge LED
Fig. 9-17