Toshiba e-STUDIO555 Service Manual page 113

No. Message
85 Time for periodic
maintenance
86 READY
(CHANGE DRAWER TO
CORRECT MEDIA TYPE)
87 PRESS [BASIC] and select
normal paper size
88 Misfeed in copier
Press [HELP]
89 Call for service
90 Please try again after
a while
91 Set standard size
92 Press START button to
copy after changing setting
93 The number of builds
exceeds the limits will you
copy stored originals?
94 The number of builds
exceeds the limits will you
save stored originals?
95 This setting cannot be
changed now
96 Service recommended for
SPC
97 Service recommended for
IQC
98 (Messages XX(SPC) and
XX(IQC) above appear
alternately.)
99 Cannot copy this size
original
100 READY(K-TONER NOT
RECOGNIZED)
Toner low
101
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
State of equipment
PM cycle
• Displayed at the time for
maintenance
• Copying is available
Displays when the printing is stopped
because of media type mismatch
Displays the warning that the copy is
not enabled when any drawer but
bypass feed is selected at Cover
Sheet Mode or Sheet Insertion Mode.
Paper jam in the equipment
• Displayed when paper jam
occurred in the equipment
Displayed when motor, sensor,
switch, etc. do not work properly
Displayed when the Department Code
can no be keyed in immediately after
power-ON.
Displayed when the paper size which
is not acceptable is set (depends on
the setting)
Displayed when the build job is set
Displayed when the number of builds
exceeds the limits
Displayed when the number of builds
exceeds the limits
Displayed when the setting is
changed during the build job is
discontinued
Displayed when the surface potential
control error occurs
Displayed when the image quality
control error occurs
Displayed when the surface potential
control error and the image quality
control error occur
Displayed if copying is not enabled
when any drawer (except bypass
feeding) is selected in the following
cases
• [BLANK TAB INSERT] or
[COPIED TAB INSERT] is set as
is the tab paper mode for the
selected drawer.
• [COPY ON TAB] is set but the tab
paper mode is not for the selected
drawer.
Displayed when a toner cartridge is
not correctly installed or an
unrecommended one is
The amount remaining in the toner
cartridge has become low.
5 - 7
Note
Maintenance and inspection are
performed by qualified service
technician.
Remove the paper in the equipment
according to the messages
displayed on the panel.
Turn OFF the main power switch
and solve the problem, then turn ON
the power.
Leave it for a while and key in the
code again
Reset the paper size
Select either printing or canceling
Select either printing or saving
Refer to chapter 5.1.16.
/Service Handbook.
Refer to chapter 5.1.15.
/Service Handbook.
Refer to chapter 5.1.15 and 5.1.16.
/Service Handbook.
If you want to replace the toner
cartridge at this time, do so following
the procedure of the
Troubleshooting Guide.
e-STUDIO555/655/755/855
CONTROL PANEL
5