Toshiba e-STUDIO555 Service Manual page 215

[D] Drum surface potential sensor (S13)
(1) Take off the cleaner unit.
( P.10-7 "[A] Cleaner unit")
(2) Disconnect 1 connector, remove 1 screw,
and then take off the sensor bracket.
(3) Disconnect 1 connector, remove 1 screw,
and then take off the surface potential sensor
(detection section).
(4) Disconnect 1 connector, release 4 lock
supports, and then take off the surface
potential sensor (board section).
Note:
The drum surface potential sensor consists
of the detection section and the board
section as a set.
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
Sensor bracket
Fig. 9-18
Connector
Drum surface potential sensor ( board section )
Fig. 9-19
Drum surface potential sensor
( detection section )
Locking support
Fig. 9-20
9 - 13
Screw
Screw
Locking support
e-STUDIO555/655/755/855
PROCESS RELATED SECTION
9