Toshiba e-STUDIO555 Service Manual page 187

(2) Remove 2 clips and take off the bypass feed
roller / pickup roller by sliding the bushing
and pulley to the inside.
(3) Remove 2 clips and pull out the shaft to take
off the pickup roller.
(4) Remove 2 clips and pull out the shaft to take
off the paper feed roller.
Notes:
1. When assembling the roller, do not install
the wrong bushing.
2. Be sure to install the feed roller in the
correct direction because it has a one-
way clutch inside it.
3. Make sure there is no staining such as oil
on the surface of the timing belt, pulley
and roller.
[C-2] Bypass feed clutch (CLT4)
(1) Disconnect the connector and then remove
the harness band and clip to take off the
bypass feed clutch.
Note:
When assembling, be sure that the stopper
of the clutch is securely inserted into the
groove of the bracket.
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
Pickup/feed roller unit
Clip
Fig. 8-36
One-way clutch
Plastic bushing
Fig. 8-37
Connector
Harness band
Fig. 8-38
8 - 25
Feed roller
Metal
bushing
Pickup roller
Clip
Bypass feed clutch
e-STUDIO555/655/755/855
PAPER FEEDING SYSTEM
8