Toshiba e-STUDIO555 Service Manual page 267

(3) Remove 2 screws.
(4) Turn the driving roller to the direction of the
arrow.
(5) Pull out the transfer belt.
Notes:
1. Install the transfer belt in the middle so
that it does not move to one side.
2. Do not touch the surface of the belt.
3. Fix the link plate securely by pressing the
rear and front side of the plate to the
direction of the arrow.
[C] Cleaning brush
(1) Take off the transfer unit.
( P.12-5 "[A] Transfer unit")
(2) Take off the transfer belt unit.
( P.12-6 "[B] Transfer belt")
(3) Remove 1 clip and then 3 gears.
Notes:
1. There are latches on gear "a" and "c".
Remove gear "a", "b" and then "c".
2. When installing the gear, be sure that the
latch is securely inserted into the groove
of the shaft.
(4) Remove 1 screw and then the plate spring.
(5) Slide the transport guide to the rear side to
pull it out upward.
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
Screw
Fig. 12-9
Fig. 12-10
Screw
Plate spring
c
a
Fig. 12-11
12 - 7
Link plate
Screw
Transfer belt
Transport guide
b
e-STUDIO555/655/755/855
TRANSFER/TRANSPORT UNIT
12