Toshiba e-STUDIO555 Service Manual page 185

(4) Disconnect 2 board connectors and release
4 lock supports to take off the board.
[B-2] Transport motor (M17)
(1) Disconnect 1 connector.
(2) Remove 2 screws to take off the motor.
[B-3] Transport roller
(1) Remove 1 E-ring to pull out the bearing from
the shaft.
(2) Remove the pin of the pulley by moving the
shaft toward the motor. Then remove the
pulley and bearing to take off the transport
roller with its shaft.
© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
Motor driving PC board
Fig. 8-30
Belt
Fig. 8-31
Pin
Pulley
Bearing
Fig. 8-32
8 - 23
Transport motor
Bearing
e-STUDIO555/655/755/855
PAPER FEEDING SYSTEM
8