Removing The Rear Wheel - Husqvarna FC 250 EU 2015 Owner's Manual

13 WHEELS, TIRES
13.3

Removing the rear wheel

–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Activate the hand brake lever multiple times until the brake linings are in contact with
the brake disc.
–
Remove the motorcycle from the lift stand. (
–
Pull the front brake and compress the fork powerfully a few times.
The fork legs straighten.
M00291-11
–
Tighten screws
Guideline
Screw, fork stub
Preparatory work
–
Raise the motorcycle with the lift stand. (
Main work
(FC 250 EU)
–
Press the brake caliper onto the brake disc by hand in order to push back the
brake piston.
–
Remove nut
–
Remove chain adjuster
rear wheel to be pushed forward.
–
Push the rear wheel forward as far as possible. Remove the chain from the rear
sprocket.
–
Holding the rear wheel, withdraw the wheel spindle. Take the rear wheel out of
the swingarm.
M00294-10
(FC 250 US)
–
Press the brake caliper onto the brake disc by hand in order to push back the
brake piston.
–
Remove nut
–
Remove chain adjuster
rear wheel to be pushed forward.
–
Push the rear wheel forward as far as possible. Remove the chain from the rear
sprocket.
–
Holding the rear wheel, withdraw the wheel spindle. Take the rear wheel out of
the swingarm.
M00065-10
 .

.
Info
Ensure that the brake caliper is not pressed against the spokes when
pushing back the brake piston.

.
 . Withdraw wheel spindle
Info
Protect the components against damage by covering them.
Info
Do not operate the foot brake when the rear wheel is removed.
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
Info
Ensure that the brake caliper is not pressed against the spokes when
pushing back the brake piston.
 .

. Withdraw wheel spindle
Info
Protect the components against damage by covering them.
M20x1.5 35 Nm (25.8 lbf ft)
p. 33)
M8 15 Nm (11.1 lbf ft)
p. 33)
 only enough to allow the

only enough to allow the
66