Removing The Rear Wheel - Husqvarna TE 125 EU 2015 Owner's Manual

14 WHEELS, TIRES
14.3

Removing the rear wheel

–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
The brake linings are positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Operate the hand brake lever several times until the brake linings are lying correctly
against on the brake disc.
–
Remove the motorcycle from the lift stand. (
M00416-11
–
Pull the front brake and compress the fork forcefully a few times.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
Preparatory work
–
Raise the motorcycle with the lift stand. (
Main work
–
Press the brake caliper onto the brake disc by hand in order to push back the brake
piston.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
–
Remove nut
–
Remove chain adjuster
rear wheel to be pushed forward.
–
Push the rear wheel forward as far as possible. Remove the chain from the rear
sprocket.
Info
Cover the components to protect them against damage.
–
Holding the rear wheel, withdraw the wheel spindle. Take the rear wheel out of the
swingarm.
Info
M00418-10
Do not operate the foot brake when the rear wheel is removed.
Always lay the wheel down in such a way that the brake disc is not damaged.
–
Remove spacers
M00428-10

.

.

.
 . Withdraw wheel spindle

.
M20x1.5 35 Nm (25.8 lbf ft)
p. 43)
M8 15 Nm (11.1 lbf ft)
p. 43)
 only enough to allow the
77