Table of Contents
Advertisement
13.2
Installing the front wheel
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
13.3
Removing the rear wheel
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
A
surfaces
Long-life grease (
–
Insert the spacers.
–
Clean and lightly grease the wheel spindle.
A01188-10
Long-life grease (
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
–
Operate the hand brake lever several times until the brake
linings are seated correctly against the brake disc.
–
Remove the motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times
firmly.
A01199-11
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
Preparatory work
–
Raise the motorcycle with a lift stand. (
WHEELS, TIRES 13
1
and contact
of the spacers.
p. 143)
p. 143)
2
.
M20x1.5
3
.
M8
35 Nm (25.8 lbf ft)
p. 49)
15 Nm (11.1 lbf ft)
p. 49)
97
Advertisement
Table of Contents
