Installing The Front Wheel; Removing The Rear Wheel - Husqvarna FE 450 EU 2020 Owner's Manual

14.2

Installing the front wheel

Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
14.3

Removing the rear wheel

–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
of the spacers.
Long-life grease (
–
Insert the spacers.
H00935-10
–
Clean and grease the wheel spindle.
Long-life grease (
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel
spindle
H03730-11
–
Operate the hand brake lever several times until the brake
linings are seated correctly against the brake disc.
–
Remove the motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
Preparatory work
–
Raise the motorcycle with a lift stand. (
WHEELS, TIRES 14
1
and contact surface
p. 155)
p. 155)
2
.
M20x1.5 35 Nm (25.8 lbf ft)
3
.
M8 15 Nm (11.1 lbf ft)
p. 55)
A
p. 55)
103