Shutdown Alarm - Smartgen HGM4100LT User Manual

5.2

SHUTDOWN ALARM

When the controller detects shutdown alarm, it will open the breaker immediately and stop the
engine. At the same time alarm type shall be displayed.
No. Type
1 Emergency Stop
2 Over Speed
3 Under Speed
4 Loss Of Speed Signal
5 Over Frequency
6 Under Frequency
7 Over Voltage
8 Under Voltage
9 Over Current
10 Fail To Start
11 High Temp. Shutdown
HGM4100LT Genset Controller
HGM4100LT GENSET CONTROLLER USER MANUAL
Table 5 Shutdown Alarms
When the controller detects emergency stop signals, it will send
stop alarm signals and the corresponding alarm information will
be displayed on LCD.
When controller detects the speed value is higher than the set
over speed stop value, it will send stop alarm signals and the
corresponding alarm information will be displayed on LCD.
When the controller detects the speed value is lower than the set
value, it will send stop alarm signals and the corresponding
alarm information will be displayed on LCD.
When the controller detects speed value equals 0, and delay
value isn't 0, it will send stop alarm signals and the
corresponding alarm information will be displayed on LCD.
When the controller detects the frequency value is higher than
the set over frequency stop value, it will send stop alarm signals
and the corresponding alarm information will be displayed on
LCD.
When the controller detects the frequency value is lower than
the set value, it will send stop alarm signals and the
corresponding alarm information will be displayed on LCD.
When the controller detects the voltage value is higher than the
set overvoltage stop value, it will send stop alarm signals and the
corresponding alarm information will be displayed on LCD.
When the controller detects the voltage value is lower than the
set value, it will send stop signals and the corresponding alarm
information will be displayed on LCD.
When the controller detects the current value is higher than the
set overcurrent stop value and the delay value is not 0, it will
send stop alarm signals and the corresponding alarm
information will be displayed on LCD.
If genset fails to start within the set start times, the controller will
send stop alarm signals and the corresponding alarm
information will be displayed on LCD.
When the controller detects water/cylinder temperature is higher
2019-01-28
Description
Version1.0 Page 15 of 48