Smartgen HGM4100LT User Manual page 14

No. Type
Maintenance
21
Due
22 Gen Over Voltage
Gen Under
23
Voltage
Gen Over
24
Frequency
Gen Under
25
Frequency
26 Charge Alt Fail
27 Over Power
28 ECU Warn
HGM4100LT Genset Controller
HGM4100LT GENSET CONTROLLER USER MANUAL
When genset running time has exceeded the users-set maintenance
time and the maintenance action is "Warn", it will initiate a warning alarm
and the corresponding alarm information will be displayed on LCD. The
maintenance alarm will reset if the action is selected "Inactive".
When controller detects the voltage is higher than the set warning value,
it will send warning signals and the corresponding alarm information will
be displayed on LCD.
When controller detects the voltage is lower than the set warning value,
it will send warning signals and the corresponding alarm information will
be displayed on LCD.
When controller detects the frequency is higher than the set warning
value, it will send warning signals and the corresponding alarm
information will be displayed on LCD.
When controller detects the frequency is lower than the set warning
value, it will send warning signals and the corresponding alarm
information will be displayed on LCD.
When controller detects the charger alt fail warning input is active, it will
send alarm signals and the corresponding alarm information will be
displayed on LCD.
When controller detects the power value (power is positive) is higher
than the set value and the action selects "warn", it will send warning
signals and the corresponding alarm information will be displayed on
LCD.
When controller gets the warning signals from the engine via J1939, it
will send warning signals and the corresponding alarm information will
be displayed on LCD.
2019-01-28
Description
Version1.0 Page 14 of 48