Volvo Edc3; Volvo Edc4; Volvo-Ems2 - Smartgen HGM4100LT User Manual

13.16 VOLVO EDC3

It is suitable for engine type TAD1240, TAD1241, and TAD1242.
Terminals of controller
Programmable output1
Start relay output
Configurable output 2
Terminals of controller
CAN_SCR
CAN(H)
CAN(L)
Engine type: Volvo.
NOTE: When this engine type is selected, preheating time should be set at least 3 seconds.

13.17 VOLVO EDC4

It is suitable for engine types TD520, TAD520 (optional), TD720, TAD720 (optional), TAD721,
TAD722, and TAD732.
Terminals of controller
Programmable output1
Start relay output
CAN GND
CAN(H)
CAN(L)
Engine type: Volvo EDC4.

13.18 VOLVO-EMS2

It is suitable for Volvo Engine types: TAD734, TAD940, TAD941, TAD1640, TAD1641, and
TAD1642.
HGM4100LT Genset Controller
HGM4100LT GENSET CONTROLLER USER MANUAL
Table 35 "Stand alone" Connector
"Stand alone" connector
H
E
P
Table 36 "Data bus" Connector
"Data bus" connector
-
1
2
Table 37 Connector
Connector
Expand 30A relay, and
relay offers battery
voltage to terminal 14.
Fuse is 16A;
-
1
-
12
13
2019-01-28
Remark
Set configurable output 1 as "Fuel Relay
Output";
ECU power;
Set configurable output 2 as "ECU power" ;
Remark
CAN communication shielding line;
Using impedance 120Ω connecting line;
Using impedance 120Ω connecting line;
Remark
Set configurable output 1 as "Fuel Relay
Output";
Connected to starter coil directly;
Connected to negative of battery;
CAN communication shielding line;
Using impedance 120Ω connecting line;
Using impedance 120Ω connecting line;
Version1.0 Page 46 of 48