Commissioning - Smartgen HGM4100LT User Manual

10 COMMISSIONING

Please make sure the following checks are made before commissioning:
— Check and make sure that all connections are correct and wire diameter is suitable.
— Check and make sure that the controller DC power has fuse, and controller's positive and negative
connections with the start battery are correct.
— Check and make sure that emergency stop input is connected to the positive pole of starter battery
via emergency stop button's normally closed point and fuse.
— Take proper action to prevent engine to crank successfully (e. g. remove the connecting wire of the
fuel valve). If everything is correct, connect power with the start battery; choose manual mode and the
controller will executive the routine.
— Set the controller under manual mode; press "start" button, and the genset will start. After the set
cranking times, the controller will send Start Failure signal, and then press "stop" to reset the controller.
— Recover the action to prevent engine to crank successfully (e. g. connect the wire of the fuel valve).
Press start button again, the genset will start. If everything goes well, the genset will go to normally
running after idling speed running (if configured). During this time, please observe engine's running
situation and AC generator's voltage and frequency. If there is something abnormal, stop the genset
and check all wire connections according to this manual.
— Select the AUTO mode on controller's panel, and make the remote start input active. The engine
shall enter normal running status automatically and then sends Gen close signal to control ATS to
transfer to genset loading. If this is not the case, please refer to this manual and check ATS control wire
connections.
— If there is any other question, please contact SmartGen's service as soon as possible.
HGM4100LT Genset Controller
HGM4100LT GENSET CONTROLLER USER MANUAL
2019-01-28 Version1.0 Page 36 of 48