Table of Contents
Advertisement
Note: Expansion relays with high capacity in start and fuel outputs are recommended.
12
INSTALLATION
12.1 FIXING CLIPS
1)
The controller is panel built-in design; and it is fixed by clips for installation.
2)
Withdraw the fixing clip screws (anticlockwise) until they reach proper position.
3)
Pull the fixing clips backwards (towards the back of the module) and ensure two clips are inside
their allotted slots.
4)
Turn the fixing clip screws clockwise steady until they are fixed on the panel.
Note: Care should be taken not to over tighten the screws of the fixing clips.
12.2 OVERALL DIMENSION
HGM4100LT Genset Controller
HGM4100LT GENSET CONTROLLER USER MANUAL
Fig. 6 2-Phase 3-Wire Connection Diagram
Fig. 7 Single Phase 2-Wire Connection Diagram
Fig. 8 Overall Dimensions
2019-01-28
Version1.0
Page 38 of 48
- Quick Links:
- Warnings
- Controller Parameter Setting
Hide quick links:
Advertisement
Table of Contents
