Replacing A Controller Node-Two-Node System Only-Sp 5.X - HPE 3PAR StoreServ 8000 Service And Upgrade Manual

Slide in the controller node (1) while pushing in on the gray rod until it stops (2).
If the UID LED is flashing blue after two minutes, this LED status indicates that the replacement
controller node is not properly seated, so repeat this step.
Figure 5: Fully install and seat the controller node into the slot
Once inserted, the replacement controller node powers up and goes through the automatic node-to-
node rescue before joining the cluster. This process might take up to 10 minutes.
IMPORTANT: If the automatic node-to-node rescue does not start automatically, contact your
authorized service provider.
Verification
14. Verify that the controller node has joined the cluster.
Confirm that the green Status LED on the controller node is flashing in synchronization with the other
controller nodes, indicating that it has joined the cluster.
15. From the SPOCC interface, verify that the State for the component and the storage system are
Normal (green).
16. After the component replacement, initiate Check Health on the storage system.
a. From the SPOCC interface main menu, click Support in the left navigation pane.
b. From the Service Processor - Support page, under StoreServs, click Health Check in the
Action column.
17. If significant time is left in the maintenance window, end the Maintenance Mode.
a. From the SPOCC interface main menu, select SPMAINT in the left navigation pane.
b. From the SPMaint interface main menu under Service Processor - SP Maintenance, select
StoreServ Configuration Management.
c. Under Service Processor - StoreServ Configuration, select Modify under Action.
d. Under Service Processor - StoreServ Info, select Off for the Maintenance Mode setting.
18. Follow the return instructions provided with the replacement component.
Replacing a controller node—Two-node system only—SP 5.x
This procedure is for the replacement of an HPE 3PAR StoreServ 8000 Storage controller node using
HPE 3PAR Service Processor (SP) 5.x.
12 Service