HPE 3PAR StoreServ 8000 Service And Upgrade Manual page 31

c. Slide the PCM out of the enclosure (3).
d. Place the PCM on the ESD mat with the battery compartment facing up.
Figure 23: Removing the AC power cooling module
10. Remove the battery from the AC PCM.
a. At the back of the PCM, lift the battery release handle (1).
b. Remove the battery from the battery compartment (2).
c. Place on the ESD safe mat.
Figure 24: Removing the battery, AC power cooling module, controller node enclosure
Replacement
11. Install the battery for the AC PCM.
a. With the battery handle in the upright position, insert the replacement battery into the PCM (1).
b. Push down the handle to install (2).
When the battery is correctly seated, the battery and handle are aligned with the surface of the
PCM.
Service 31