Replacing An Sfp Transceiver-Sp 5.X - HPE 3PAR StoreServ 8000 Service And Upgrade Manual

a. From the SPOCC interface main menu, click Support in the left navigation pane.
b. From the Service Processor - Support page, under StoreServs, click Health Check in the
Action column.
16. If significant time is left in the maintenance window, end the Maintenance Mode.
a. From the SPOCC interface main menu, select SPMAINT in the left navigation pane.
b. From the SPMaint interface main menu under Service Processor - SP Maintenance, select
StoreServ Configuration Management.
c. Under Service Processor - StoreServ Configuration, select Modify under Action.
d. Under Service Processor - StoreServ Info, select Off for the Maintenance Mode setting.
17. Follow the return instructions provided with the replacement component.
Replacing an SFP transceiver—SP 5.x
This procedure is for the replacement of a small form-factor pluggable (SFP) transceiver using HPE 3PAR
Service Processor (SP) 5.x. An SFP transceiver is installed in each onboard Fibre Channel (FC) port and
in the ports of host adapters.
WARNING: When the storage system is on, do not stare at the FC fibers because doing so could
damage your eyes.
CAUTION: To prevent damage when handling the SFP transceiver, do not touch the gold contact
leads.
IMPORTANT: All SFP ports must contain an SFP transceiver and cable or a dust cover.
Prerequisites
Order a replacement component by contacting your Hewlett Packard Enterprise authorized service
provider.
Procedure
Preparation
1. Unpack the component and place on an ESD safe mat.
2. Connect to the service processor in the Service Console interface:
Browse to the IP address: https://<sp_ip_address>:8443
3. Log in to the HPE 3PAR SP and enter the admin account credentials.
4. Initiate a maintenance window to stop the flow of alerts to Hewlett Packard Enterprise.
a. From the Service Console interface, select Systems.
b. Select Actions > Set maintenance mode and then follow the instructions.
Service 53