Two-Port 32Gb Fc Hba Information; Breaker Panel Information; Direct-Current E-T-A Breaker Panel And Grounding Bar Information; Controller Node Information - HPE 3PAR StoreServ 8000 Service And Upgrade Manual

Two-port 32Gb FC HBA information

This information applies only to the HPE 3PAR Two-Port 32Gb FC Host Bus Adapter for the HPE 3PAR
StoreServ 8000 Storage systems.
Use 32Gb SFP28 transceiver connectors with the ports.
Figure 56: HPE 3PAR Two-Port 32Gb FC Host Bus Adapter ports
Port
1
2

Breaker panel information

Direct-current E-T-A Breaker Panel and Grounding Bar information

The direct-current (DC) E-T-A Breaker Panel is supported for the HPE 3PAR StoreServ 8000 Storage
system when installing the system in a direct-current power environment.
For installation in the DC HPE 3PAR StoreServ 8000 Storage system, two DC Breaker Panels and two
Grounding Bars are installed as a set. This provides a total of 32 outputs (or 16 redundant outputs).
• The DC Breaker Panel is the DC equivalent to the AC Power Distribution Unit (PDU).
• The Grounding Bar is installed on the Breaker Panel and is the central ground to which all components
and the rack itself will be grounded. The grounding bars are then connected to the facility ground (as
opposed to connecting the grounding bar to the rack and grounding the rack to the facility).

Controller node information

This information applies only to the controller nodes for the HPE 3PAR StoreServ 8000 Storage system.
IMPORTANT: The controller nodes in the controller node enclosure are inverted 180° from each
other, as well as the ports.
Figure 57: Controller node numbering, two-node controller node enclosure rear view
Node:Slot:Port (N:S:P)
N:2:1
N:2:2
More information 93