System Status Leds-Controller Node Enclosure - HPE 3PAR StoreServ 9000 Customer Self Install Manual

Table 26: Physical service processor LEDs, HPE ProLiant DL360 Gen10 Server
front view
LED function
1
UID button/
LED*
2
Power on/
Standby
button and
power LED*
3
Health LED*
4
NIC status
LED*
*When all four LEDs described in this table flash simultaneously, a power fault has occurred.
System status LEDs—controller node enclosure
The HPE 3PAR StoreServ 9000 Storage system status LEDs are at the front, right corner of the controller
node enclosure.
Figure 63: System status LEDs, controller node enclosure front view
Status State
Blue solid Activated
Blue flashing 1 Hz = Remote management or firmware upgrade in progress
4 Hz = iLO manual reboot sequence initiated
8 Hz = iLO manual reboot sequence in progress
Off = Deactivated
Green solid System on
Green flashing Performing power on sequence
Amber solid System in standby
Off No power present
Facility power is not present, power cord is not attached, no power
supplies are installed, power supply failure has occurred, or the
power button cable is disconnected.
Green solid Normal
Green flashing iLO is rebooting
Amber flashing System degraded
Red flashing System critical
If the health LED indicates a degraded or critical state, review the
system IML or use iLO to review the system health status.
Green solid Link to network
Green flashing Network active
Off No network activity
More information 87