HPE 3PAR StoreServ 8000 Service And Upgrade Manual page 11

a. Pull to extend the gray rod of the controller node to the extracted position.
Figure 2: Extending the controller node rod
b. Confirm that the controller node is correctly oriented. In the controller node enclosure, the pair is
installed with each controller node oriented 180° from each other.
Figure 3: Orientation of a controller node pair
c. Partially install the controller node into the slot. Using two hands to grasp each side of the
replacement controller node, align it with the grooves in the slot, and slide it into the slot until it
halts against the insertion mechanism that is inside of the slot. Do not fully insert the controller
node in the slot at this time, because the cables must be reconnected before it is fully seated.
Figure 4: Partially install the controller node into the slot
12. Reconnect the cables to the controller node.
While the controller node is still only partially inserted in the slot, reconnect the cables to the
controller node.
13. Fully install and seat the controller node into the slot. See Figure 5: Fully install and seat the
controller node into the slot on page 12.
Service 11