HPE 3PAR StoreServ 8000 Service And Upgrade Manual page 153

network example 1
Network -- "IP address change has not been completed"
network suggested action 1
The setnet command was issued to change some network parameter, such as the IP address, but the
action has not been completed. Use setnet finish to complete the change, or setnet abort to
cancel. Use shownet to examine the current condition.
cli% shownetIP Address
Status
192.168.56.209
192.168.56.233
network example 2
Component ---Identifier---- -----Detailed Description----------
Network Node0:Admin
network suggested action 2
Network errors have been detected on the specified node and network interface. Commands such as
shownet and shownet -d are useful for troubleshooting network problems. These commands display
current network counters as checkhealth compares error with the last logging sample.
NOTE: The error counters shown by shownet and shownet -d cannot be cleared except by rebooting
a controller node. Because checkhealth is comparing network counters with a history log,
checkhealth stops reporting the issue if there is no increase in error in the next log entry.
cli% shownet -dIP Address: 192.168.56.209
Assigned to nodes: 0123
Connected through node 0
Status: Active
Admin interface on node 0
MAC Address:
RX Packets:
RX Bytes:
RX Errors:
RX Dropped:
RX FIFO Errors:
RX Frame Errors:
RX Multicast:
RX Compressed:
pd
Displays physical drives (PDs) with states or conditions that are not optimal:
• Checks for failed and degraded PDs
• Checks for an imbalance of PD ports, for example, if Port-A is used on more Drives than Port-B
Netmask/PrefixLen
255.255.255.0 0123
255.255.255.0 0123
Errors detected on network
00:02:AC:25:04:03
1225109
1089073679
Nodes Active Speed
0 100 Full
0 100 Full
Netmask 255.255.255.0
TX Packets:
TX Bytes:
0 TX Errors:
0 TX Dropped:
0 TX FIFO Errors:
60 TX Collisions:
0 TX Carrier Errors:
0 TX Compressed:
Duplex AutoNeg
Yes Changing
Yes Unverified
550205
568149943
Troubleshooting
0
0
0
0
0
0
153