Qos - HPE 3PAR StoreServ 8000 Service And Upgrade Manual

cli% showport -sfp
N:S:P -State- -Manufacturer- MaxSpeed(Gbps) TXDisable TXFault RXLoss DDM
0:1:1 OK
0:1:2 OK
1:1:1 -
1:1:2 OK
port example 3
cli% checkhealth -detail port
port suggested action 3
Check the state of the port with showport. If a port is offline, it was deliberately put in that state using the
controlport offline command. Offline ports might be restored using controlport rst.
cli% showportN:S:P
...
0:0:1 target
0:0:2 target
...
port example 4
Component ------------Summary Description------------ Qty
Port Ports with mismatched mode and type
Component -Identifier- ------Detailed Description-------
Port port:2:0:3
port suggested action 4
This output indicates that the port mode, such as an initiator or target, is not correct for the connection
type, such as drive, host, ISCSI, FCoE, or RCFC. Useful HPE 3PAR CLI commands are showport,
showport -c, showport -par, showport -rcfc, showcage, and so on.
cli% showport
Component -Identifier- ------Detailed Description-------
Port port:0:1:1
cli% showport
N:S:P Mode
0:1:1 initiator
0:1:2 initiator loss_sync 2FF70002AC000190
0:1:3 initiator loss_sync 2FF70002AC000190
0:1:4 initiator loss_sync 2FF70002AC000190

qos

• Displays Quality of Service (QoS) issues
• Checks for Quality of Service rejects over the previous 24 hours
Format of possible qos exception messages
QOS <vvsetname> "VVSet has logged <count> rejects in 24 hours"
160 Troubleshooting
HP-F
HP-F
-
HP-F
Mode State ----Node_WWN---- -Port_WWN/HW_Addr-
ready 2FF70002AC00006E
offline 2FF70002AC00006E
Mismatched mode and type
Mismatched mode and type
State ----Node_WWN---- -Port_WWN/HW_Addr- Type
ready 2FF70002AC000190
8.5 No
8.5 No
- -
8.5 No
20110002AC00006E host
20120002AC00006E free
20110002AC000190 rcfc
20120002AC000190 free
20130002AC000190 free
20140002AC000190 free
No No
No Yes
- -
No Yes
Type Protocol Label Partner FailoverState
FC - 1:0:1
FC - 1:0:2
1
Yes
Yes
-
Yes
none
none