HPE 3PAR StoreServ 8000 Service And Upgrade Manual page 27

Figure 19: Removing the AC power cooling module
11. Remove the battery from the AC PCM.
a. At the back of the PCM, lift the battery release handle (1).
b. Remove the battery from the battery compartment (2).
c. Place on the ESD safe mat.
Figure 20: Removing the battery, AC power cooling module, controller node enclosure
Replacement
12. Install the battery for the AC PCM.
a. With the battery handle in the upright position, insert the replacement battery into the PCM (1).
b. Push down the handle to install (2).
When the battery is correctly seated, the battery and handle are aligned with the surface of the
PCM.
Service 27