Address Assignment Of The Vacuum Generator; Transport And Storage; Assembly; Mounting Types - Festo VTSA-F-CB Manual

Assembly

Component
Manifold sub-base for the pilot air switching valve with additional valve position
VABV-S4-2HS-G18-CB-2T5
VABV-S4-12HS-G-CB-2T5
VABV-S4-12HS-G-CB-2T2
Manifold sub-base for the soft start valve
VABV-S6-1Q-G38-CB1-T5
VABV-S6-1Q-G38-CB-T5
1) The switching signal of the pressure switch is sent to the CPX terminal via the internal communication.
2) The switching signal of the pressure switch can be used in an external controller via the M12 connection.
Tab. 32: Address assignment of the special valves
4.4.3

Address assignment of the vacuum generator

The vacuum generator is an independent bus participant. The vacuum generator does not occupy any
addresses of the pneumatic interface.
Component
Vacuum generator
VABF-S4-2-V2B1-G38-CB-...
Tab. 33: Address assignment of the vacuum generator
5

Transport and storage

Depending on the configuration, the valve terminal can weigh >15 kg and be quite long.
– Use suitable lifting equipment for the specified weight è Delivery note.
– If present, do not remove the wooden substructure until after transport.
6 Assembly
6.1

Mounting types

Depending on the design of the CPX modules, the following mounting types are possible:
50
Width [mm]
1 x 18 (left)
Pressure switch with internal evaluation
1 x 18 (right)
1 x 18 (left)
Pressure switch with internal evaluation
1 x 26 (right)
1 x 18 (left)
Pressure switch with external evaluation
1 x 26 (right)
1 x 40
Soft-start valve
Pressure switch with internal evaluation
Number of valve positions
1
Number of assigned
addresses
0
1)
2
0
1)
2
2
2)
2
0
1)
Number of assigned addresses
0
Festo — VTSA-F-CB — 2021-06a