GE Baker Hughes Masoneilan SVI FF Installation And Operation Manual page 194

Parameter (in bold)
Sub-parameter (Index)
Manufacturer
Model
Qty
ACCESSORY (113)
SOLENOID
REMOTE_SENSOR
POSITION_EXTREMES
(114)
FINAL_VALUE_MAX (1)
FINAL_VALUE_MIN (2)
FINAL_POS_VALUE_-
MAX (3)
FINAL_POS_
VALUE_MIN (4)
WORKING_SP_MAX (5)
WORKING_SP_MIN (6)
WORKING_POS_MAX (7) -50 to
WORKING_POS_MIN (8)
194 |
BHGE
Table 31 Transducer Block Parameters (Continued)
Initial
Mode
Range
Value
Auto,
Man,
OOS
0-1 read 0
2-3 write
Auto,
Man,
OOS
-50 to -50
199
-50 to 199
199
-50 to -50
199
-50 to 199
199
-50 to -50
199
-50 to 199
199
-50
199
-50 to 199
199
Description
Indicates/Enables the remote sensor connection. The fol-
lowing enumeration is available:
0: Remote sensor is disabled/Not Active (read only -
write does nothing).
1: Remote sensor is enabled (read only - write does
nothing).
2: Enable Local HAL Sensor (write only - write does
nothing if it is already 0).
3: Enable Remote Sensor (write only - write does noth-
ing if it is already 1).
MUST restart device for the change to take effect.
Minimum and Maximum position values observed since
start or the last update from the user.
FINAL VALUE: Maximum value detected since last update
from the user.
FINAL VALUE: Minimum value detected since last update
from the user.
FINAL POSITION VALUE: Maximum value detected since
last update from the user.
FINAL POSITION VALUE: Minimum value detected since
last update from the user.
WORKING_SP: Maximum value detected since last update
from the user.
WORKING_SP: Minimum value detected since last update
from the user.
WORKING_POS: Maximum value detected since last
update from the user.
WORKING_POS: Minimum value detected since last
update from the user.
© 2019 Baker Hughes, a GE company, LLC. All rights reserved.